SimTech WeldTech Uživatelský manuál stáhnout pdf (Strana 17)

WeldTech - MaxiPlast Instruction Manual

SIMTECH

Phone: 877-777-2467 • Fax: 215-547-3410

www.SimtechUSA.com

1.031213

5. Starting and Operating

The instructions of this chapter are supposed to initiate in the operation of the machine and lead during

the appropriate starting of the machine.

This includes

• The safe operation of the machine

• Using all the possible options of the machine

• Economic operation of the machine

5.1. Starting

The machine should only be operated by initiated and authorized people.

For the qualiﬁcation a plastic welding exam can be taken according to DVS and DVGW.

If dangers occur unplug the machine immediately.

Switch off the machine after the work and during pauses. Make sure that

unauthorizedpeople are kept at a distance. Protect the machine from wetness and

moisture.

For working at the building site use a current distributor with a FI-security

protective.

Lay electric cables thoroughly (danger of stumbling) !

• Take care of the surrounding conditions:

• The welding should not be performed under direct sun rays inuence, use a

welding umbrella if necessary.

• In case of surrounding temperature under 5° C measures should be taken :

• Build up a welding tent or heat up the pipe ends if necessary.

• ake measures against rain, wind and dust.

• Connect the heating element to the mains supply (110V / 50 Hz).

5.1.1 Change of the Reduction Inserts

• Unscrew the in-screwed reduction inserts by means of the enlcosd Allan key.

• Screw on reduction inserts of the desired diameter.

• With respect to curves, the angle on the basic clamping tools can be set (on each side between

-15° to +45°).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Žádné komentáře

SimTech WeldTech Uživatelský manuál Strana 17